Development of a novel method for the exploration of the thermal response of superfluid helium cooled superconducting cables to pulse heat loads

Tiemo Winkler, T. Koettig, R. van Weelderen, J. Bremer, Hermanus J.M. ter Brake

Research output: Contribution to journalArticleAcademicpeer-review

1 Citation (Scopus)
62 Downloads (Pure)

Abstract

Management of transient heat deposition in superconducting magnets and its extraction from the aforementioned is becoming increasingly important to bring high energy particle accelerator performance to higher beam energies and intensities. Precise knowledge of transient heat deposition phenomena in the magnet cables will permit to push the operation of these magnets as close as possible to their current sharing limit, without unduly provoking magnet quenches. With the prospect of operating the Large Hadron Collider at CERN at higher beam energies and intensities an investigation into the response to transient heat loads of LHC magnets, operating in pressurized superfluid helium, is being performed. The more frequently used approach mimics the cable geometry by resistive wires and uses Joule-heating to deposit energy. Instead, to approximate as closely as possible the real magnet conditions, a novel method for depositing heat in cable stacks made out of superconducting magnet-cables has been developed. The goal is to measure the temperature difference as a function of time between the cable stack and the superfluid helium bath depending on heat load and heat pulse length. The heat generation in the superconducting cable and precise measurement of small temperature differences are major challenges. The functional principle and experimental set-up are presented together with proof of principle measurements.
Original languageUndefined
Pages (from-to)602-606
Number of pages5
JournalPhysics procedia
Volume67
DOIs
Publication statusPublished - 2015

Keywords

  • METIS-313924
  • IR-98786

Cite this