Drone‐based photogrammetry‐derived crown metrics for predicting tree and oil palm water use

Transpiration at the stand level is often estimated from water use measurements on a limited number of plants and then scaled up by predicting the remaining plants of a stand by plant size-related variables. Today, drone-based methods offer new opportunities for plant size assessments. We tested crown variables derived from drone-based photogrammetry for predicting and scaling plant water use. In an oil palm agroforest and an oil palm monoculture plantation in lowland Sumatra, Indonesia, tree and oil palm water use rates were measured by sap flux techniques. Simultaneously, aerial images were taken from an octocopter equipped with an Red Green Blue (RGB) camera. We used the structure from motion approach to compute several crown variables such as crown length, width, and volume. Crown volumes for both palms (69%) and trees (81%) explained much of the observed spatial variability in water use; however, the specific crown volume model differed between palms and trees and there was no single linear model fitting for both. Among the trees, crown volume explained more of the observed variability than stem diameter, and in consequence, uncertainties in stand level estimates resulting from scaling were largely reduced. For oil palms, an appropriate whole-plant size-related predictor variable was thus far not available. Stand level transpiration estimates in the studied oil palm agroforest were lower than those in the oil palm monoculture, which is probably due to the small-statured trees. In conclusion, we consider drone-derived crown metrics very useful for the scaling from single plant water use to stand-level transpiration.